ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in   

DU oilless dry bushing manufacturer

 
Post new topic   Reply to topic    Ninja Fortress Forum Index -> Ninja Gaiden 3: Razor's Edge
View previous topic :: View next topic  
Author Message
slidebearing
Lesser Ninja
Lesser Ninja


Joined: 16 Feb 2016
Posts: 15



PostPosted: Sun Mar 06, 2016 8:07 pm    Post subject: DU oilless dry bushing manufacturer Reply with quote

InductionDX sleeve bushing heater can be compared with the transformer, it works is to a large number of turns of the primary coil and a copper sleeve manufacturers of secondary winding turns less installed on the same core. Input and output voltage ratio is equal to the ratio of the number of turns of the coil, while energy maintenance-free bearings guarantee remains unchanged. Therefore, the secondary coil to produce a large current at a low voltage condition. For the speed of the card bearing induction heater, the DU oilless dry bushing is a single-turn secondary winding shorted, at a lower AC voltage flows at high amperage, thus generating a lot of heat due. The heater itself and the yoke is kept at room temperature.
Back to top
View user's profile Send private message Visit poster's website AIM Address
Display posts from previous:   
Post new topic   Reply to topic    Ninja Fortress Forum Index -> Ninja Gaiden 3: Razor's Edge All times are GMT - 7 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group